Timber Core HPL System
Selection Guide » Timber Core HPL System
The TC HPL System is designed for those applications used for computer/ data/ comms/ switch room applications incorporating a 1.6mm thick anti-static HPL covering. The HPL protects individuals from voltage shorts that can occur with electrical equipment on an access floor and also creates an electrostatic discharge which helps prevent buildup of the static electricity which can cause damage to the equipment. This system is recommended for applications such as:
- IT Rooms
- Comms Rooms
- Switch Rooms
- Data Centre
Gravity Fixed Panels:
Panels are gravity fixed to the Understructure with stringers providing location and extra strength.
HPL Finish:
1.6mm High pressure laminate finish applied to panel in ASP standard finish. Custom and specialised HPL colours available upon request. The HPL panel is then finished with a brown edge, which is designed to eliminate panel chipping and delamination.
Carbon Powder Coating, Nickel Platting and Hot Dipped Galvanized Stringers:
For specialized sensitive areas such as clean rooms and data centres, ASP has introduced carbon based powder coated panels and pedestal tubes as well as nickel chrome platted pedestal head, threaded rod and nuts. The stringers are hotdipped galvanized. This specialised finish is availabe upon request.
Finishing Panels
Full bearing 600 x 300mm and 600 x 800mm panels designed to minimise small off cuts experienced with cutting around columns and finishing off to the perimeter. The 600 x 300 panel may also be used when there is a necessity for a 300mm x 600mm air grille.
FFH Combinations
180-1200mm FFH S8 and S8 UK Combination
1200mm + FFH S11 Combination
Field / Perimeter Pedestal:
S8, S8 UK, S11
The pedestal head remains the same for the entire system, where only minor changes are made to the pedestal tubes to suit the desired FFH.
Stringer: SC-S600
The stringer design is the same throughout the range. Predrilled holes at the end of each side allow the stringer to be screw fixed onto the pedestal head forming a rigid grid system. The top of the stringer comprises of 3mm sponge rubber foam providing a buffer between the stringer and the panel.
